PB-300P-120 - 300W 12V 12.5A PFC Single Output Battery Charger
Home > Products > PB-300P Series 300W PFC Single Output Battery Charger > 300W 12V 12.5A PFC Single Output Battery Charger
.jpg)
|
DescriptionDesigned for lead acid batteries featuring 3 stage charging characteristics and the automated derating capability for charging current under high ambient temperatures, these intelligent chargers will quickly and efficiently feed your hungry batteries and ensure the lifetime of them at the same time. With the passive PFC function PB-300 can comply with the harmonic requirements of EN61000-3-2 & equiped with an IEC320 C14 AC Inlet and ON/OFF switch this unit is very convenient for both household and general consumer use. The 48.5mm low profile design also solves a lot of installation troubles and space issues.
Standards
|
General Specifications
| Input Voltage |
90 to 132VAC / 180 to 264VAC selected by switch |
| Input Frequency |
47 to 63Hz |
| Power Factor |
>0.65 typically at 230VAC |
| AC Current |
6A/115VAC 3A/230VAC |
| Inrush Current |
60A cold start |
| Leakage Current |
<3.5mA / 240VAC |
| Battery Type |
Open & Sealed Lead Acid |
| Over Load Protection |
90 to 110% rated output current |
|
Constant current limiting, recovers automatically after fault condition is removed |
| Reverse Polarity Portection |
By internal fuse |
| Over Temperature Protection |
Automatically derate charge current until zero |
| Working Temperature |
-10°C to +40°C (Refer to output load derating curve) |
| Working Humidity |
20% to 90% RH non-condensing |
| Storage Temperature, Humidity |
-40°C to +85°C, 10% to 95% RH |
| Temperature Coefficient |
±0.05%/°C (0°C to 45°C) |
| Vibration |
10 to 500Hz, 2G 10min./1cycle, 60min. each along X, Y, Z axes |
| Safety Standards |
EN60335-2-29 CB Approved by TUV |
| Withstand Voltage |
I/P-O/P:3KVAC I/P-FG:1.5KVAC O/P-FG:0.5KVAC |
| Isolation Resistance |
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC |
| EMC |
Compliance to EN55022 (CISPR22) Class B, EN61000-3-2,-3 |
|
EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, Light industry level, criteria A |
| MTBF |
115.8Khrs minimum. MIL-HDBK-217F (25°C) |
|
PB-300P-12 Output Data
|
Boost Charge Volt
|
Float Charge Volt
|
Voltage Adj.
|
Recommended Batt Cap
|
Output Current
|
Cont. Outptu Current
|
Eff.
|
|
14.4V
|
13.6V
|
13 ~ 14.7V
|
80 ~ 200Ah
|
20.85A
|
12.5A
|
85%
|
|
 (321KB)
|
| Add this product to your ClipBook |
.jpg)
