|
DescriptionThese limited power sources comply with UL1310 class 2 that under any situation the output power will remain less than 100VA or 5A. This will significantly reduce the hazardous condition exposed to the technicians who execute the construction or maintenance of the LED lighting system. The IP64 enclosure design can protect the electronic components against dust and moisture and makes them suitable for use at indoor or outdoor locations.
Thanks to the simplified single stage PFC topology, the required high power factor, as well as the class C harmonic level for the lighting industry, can be achieved economically. Efficiency's of PLN-30 series are as high as 86% and hence can operate between -30°C ~ +50°C by only free air convection inside the fully covered plastic enclosure.
Standard functions include short circuit, over load, over voltage, and over temperature protections. The adjustable output voltage and current level enables the fine tuning of the PSU to comply with the requirement of LED characteristics.
Standards
|
General Specifications
| Input Voltage |
90 ~ 264Vac |
| Input Frequency |
47 ~ 63Hz |
| Power Factor |
PF>0.9/230Vac PF>0.95/115Vac at full load |
| Input Current |
0.4A/115Vac 0.2A/230Vac |
| Inrush Current |
40A/230Vac |
| Leakage Current |
0.5mA/240Vac |
| Output Voltage Adjustment Range |
±10% |
| Current Adjustment Range |
3% ~ -25% |
| Output Voltage Tolerance |
±10% |
| Line Regulation |
±3.0% |
| Load Regulation |
±10% |
| Set Up, Rise Time |
1500ms, 150ms / 230Vac 3000ms, 150ms / 115Vac at full load |
| Over Current Protection |
110 ~ 120% |
|
Constant current limiting, recovers automatically after fault condition is removed |
| Short Circuit Protection |
Hiccup mode, recovers automatically after fault condition is removed |
| Over Voltage Protection |
Shut down o/p voltage, re-power on to recover |
| Over Temperature Protection |
85°C ±5°C (TSW1) |
|
Shut down o/p voltage, re-power on to recover |
| Working Temperature |
-30°C ~ +50°C (Refer to output load derating curve) |
| Working Humidity |
20 ~ 90% RH non-condensing |
| Storage Temperature, Humidity |
-40°C ~ +80°C, 10 ~ 95% RH |
| Temperature Coefficient |
±0.06%/°C (0°C ~ 50°C) |
| Vibration |
10 ~ 500Hz, 2G 10min./1cycle, period for60min. each along X,Y, Z axes |
| Withstand Voltage |
I/P-O/P:3KVAC |
| Isolation Resistance |
I/P-O/P:100M Ohms/500VDC 25°C 70%RH |
| Safety Standards |
UL1310 Class 2, CAN/CSAC22.2 No. 223-M91(except for 48V), EN61347-1, EN61347-2-13, IP64 Approved |
| EMC |
Compliance to EN55015; EN61000-3-2,-3; |
|
EN61000-4-2,3,4,5,6,8,11; ENV50204, EN55024, EN61547, Light industry level, criteria A |
| MTBF |
621.4Khrs min. MIL-HDBK-217F (25°C) |
|
.jpg)
